C3060A
v1.0, C3060B V1.0
High efficiency wide input voltage
PFC programmable Charger
90V~265VAC input
For 7S LiPo, 8S LiFe battery
1~60Amps 1500W max.
www.chargery.com
page
5
total
19
Operation Instructions
1.
Connect C3060A/B to AC 110 / 220V outlet by the special heavy power cable, if use other brand
cable, please note the wire AWG must be AWG14 at least.
2.
Connect battery to charger.
3.
Connect Chargery BMS8T to charger if possible.
4.
2 seconds later, the idle interface is displayed; the charger is ready to charge. Actual output voltage,
current and internal temperature is also displayed, but C3060A/B is at idle mode (no output) to save
power consumption.
5.
Press
knob
shortly can choose Battery type; press again on
Battery type such as LiPo can enter into LiPo charge setup
interface. Here, you can setup cell count, charge current,
charge terminal current, and charge terminal voltage per
cell, and then press
knob
for 3 seconds start charging.
6.
Stop charging, the battery voltage will goes down because
of self-discharge, if need maintain battery voltage, please setup the
Restart Charge
YES (only for
C3060B), the charger will continue to charge when battery
voltage goes down to 5% of total battery voltage.
If set up to
YES
, the charger display KEEP after charge
finished.
If set up to
NO
, the charger display DONE after charge
finished.
