C3060A
v1.0, C3060B V1.0
High efficiency wide input voltage
PFC programmable Charger
90V~265VAC input
For 7S LiPo, 8S LiFe battery
1~60Amps 1500W max.
www.chargery.com
page
15
total
19
Error Information
When the following error events trigged, the beeper will sound for 10 seconds and error information will
be displayed, you can press
knob
button
turn off beeper sound and back up to Idle or auto mode
interface.
Error information
DESCRIPTION
Battery Vol. low
No battery connection or reverse polarity of battery
connection or short circuit on output, the charger will be
power off
Battery Vol. High
Battery voltage over setup, the charger will be power off
Over Current
Output current over 2A of setup for 2 seconds, C3060A/B
turn off automatically and turn on manually
Over Voltage
Output voltage over 2V of setup for 2 seconds, C3060A/B
turn off automatically and turn on manually
Over temperature
The heat sink temperature over setup for 2 seconds,
C3060A/B power off automatically, and turn on manually
Connection Break
At normal charge, disconnect battery, the charger will stop
charging, press Knob back up to idle interface
Warnings
Never leave the charger unattended when it power on. If any malfunction is observed, please
press Knob button power off the charger as fast as possible.
Keep away the charger from dust, damp, rain, heat direct sunshine and vibration. Do not drop it.
The charger should be set up on non-inflammable and non-conductive surface. Never place on a
car seat, carpet or similar.
Keep all the inflammable volatile materials well away from operating area.
Do not attempt to charge any Lithium battery not built-in BMS, PCM, cell voltage monitor
