8
4754960
9
s
LP gas tank should be filled at this time to a
maximum of 80% fill level with LP gas before
attaching to cart.
s
Position LP tank as shown for placement into
plastic base.
Failure to install tank correctly may allow gas hose to
be damaged in operation.
Tighten thumbscrew to hold tank in position
LP Tank
Base
10
1. Turn control knob OFF.
2. Turn LP tank OFF by turning hand wheel clockwise to a
full stop (A)
.
3. Remove the protective cap from LP tank valve. Always use cap and
strap supplied with valve.
4.
Hold regulator, insert nipple (B) into LP tank valve.
Nipple
must be centered in LP tank valve.
Hand tighten coupling nut,
holding regulator in a straight line (C) with LP tank valve
so as not to cross thread the connection.
5. Turn coupling nut clockwise to tighten to a full solid stop. The regulator
will seal on the back-check feature in LP tank valve, resulting in some
resistance.
An additional one-half to three quarters turn is
required to complete connection. Tighten by hand only - do not
use tools.
Note: If you cannot complete the final connection, disconnect regulator and
repeat steps 4 and 5. If you are still unable to complete the
connection,
do not use this valve and regulator!
6. Follow "Leak Test" instructions.
Safety Relief
Valve
OPD Hand Wheel
Strap and Cap
Nipple has to be centered
into the LP tank valve
A
B
Hold coupling nut and regulator as shown for
proper connection to LP tank valve
Regulator
Coupling
Nut
ON
C
Off
Clock
wise
Type 1 outlet with
thread on outside
