Page 5
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
DANGER
• NEVER store a spare cylinder under or near the
appliance or in an enclosed area.
• Never fill a cylinder beyond 80% full.
• An overfilled or improperly stored cylinder is a hazard
due to possible gas release from the safety relief valve.
This could cause an intense fire with risk of property
damage, serious injury or death.
• If you see, smell or hear gas escaping, immediately get
away from the LP cylinder/appliance and call your fire
department.
Do not lean over grill while lighting.
1. Open lid during lighting.
2.
3.
4.
5.
Make sure LP cylinder is properly
connected to regulator.
Turn regulator control knob to
HIGH
setting.
Repeatedly press ignitor pushbutton to light the burner..
If ignition does NOT occur in 5 seconds, turn the regulator
control knob
OFF,
wait 5 minutes and repeat the lighting
procedure.
If IGNITOR does not work, follow match lighting instructions.
Turn controls OFF and disconnect cylinder when not
in use.
WARNING
Before Your First Cookout.
Turning Grill Off
Leak test your grill.
Light burner, check to make sure it is lit,
close the lid and warm up grill on HIGH for 10 minutes. Curing
of paint and parts will produce an odor only on first lighting.
Match Lighting
1.
Attach match to match lighting stick, light match.
2.
Insert lit match through gap between trough and grill bottom,
next to burner. Turn regulator control knob to
HIGH
setting.
3.
If ignition does NOT occur in 5 seconds, turn the regulator
control knob
OFF,
wait 5 minutes and repeat the lighting
procedure.
Gap
Ignitor Lighting
Safety Tips
?
The use of alcohol, prescription or nonprescription drugs
may impair the consumer’s ability to properly assemble or
safely operate the appliance.
?
When grill is not in use, disconnect 1 lb. cylinder.
?
Never move grill while in operation or still hot. Allow the
appliance to cool before moving or storing.
?
Maximum load for side shelves is 10 lbs.
?
The regulator may make a humming or whistling noise
during operation. This will not affect safety or use of grill.
?
If you have a grill problem see the Troubleshooting Section.
?
Light burner. Check to make sure they are lit, close the lid
and warm up grill on high for 10 minutes. Curing of paint
and parts will produce an odor only on first lighting.
?
Grill is not to be used as a heater.
?
This appliance will be hot during and after use. Use insulated
oven mitts or gloves for protection from hot surfaces or
splatter from cooking liquids.
?
Clean grill often, preferably after each cookout. If a bristle
brush is used to clean any of the grill cooking surfaces,
ensure no loose bristles remain on cooking surfaces prior to
grilling. It is not recommended to clean cooking surfaces
while grill is hot.
Match
lighting
stick
Trough
Make sure burner lights and stays lit.
• Turn regulator control knob to the OFFposition.Make sure the
regulator control knob pops up. If it does not, discontinue use
and order a new part.
• Disconnect 1 lb. Cylinder.
