Page 10
Troubleshooting (
continued
)
Problem
Burner(s) will not light
using ignitor.
Burner(s) will not
match light.
Low flame, drop in gas
flow.
Flames blow out.
Flare-up.
Persistent grease fire.
Flashback...
(fire in burner tube(s)).
Possible Cause
PIEZO PUSH-BUTTON AND ROTARY:
•Push-button sticks at bottom.
•Sparking between ignitor and electrode.
•See
“GAS ISSUES:”
on previous page.
•Match will not reach using match holder.
•Improper method of match-lighting.
•Out of gas.
•High or gusting winds.
•Low on LP gas.
•Grease buildup.
•Excessive fat in meat.
•Excessive cooking temperature.
•Grease trapped by food buildup in
trough
•Burner and/or burner tubes are blocked.
Prevention/Solution
•Replace ignitor.
•Inspect wire insulation and proper connection. Replace ignitor wires /
electrode assembly if insulation is broken.
•Use long-stem match (fireplace match).
•See “Match-Lighting” section of Use and Care.
•Check for gas in LP cylinder.
•Turn front of grill to face wind or increase flame height.
•Replace LP cylinder.
•Clean trough / burner and inside of grill/firebox.
•Trim fat from meat before grilling.
•Adjust (lower) temperature accordingly.
•Turn regulator control knob to OFF. Turn gas off at LP cylinder. Leave
all parts.
and clean
•Turn knob to OFF. Clean burner and/or burner tubes. See burner
cleaning section of Use and Care.
lid in closed position and let fire burn out. After grill cools, remove
