12
Burner Flame Check
• Remove cooking grates and flame tamers. Light burners, rotate
knobs from HIGH to LOW . You should see a smaller
flame in
LOW position than seen on HIGH. Perform burner
flame check on sideburner, also. Always check flame prior to
each use. If only low flame is seen refer to "Sudden drop or low
flame" in the
Troubleshooting Section
.
HIGH
LOW
Turning Grill Off
• Turn all knobs to
position. Turn LP cylinder off by
turning hand-wheel clockwise to a full stop.
Ignitor Check
• Turn gas off at LP cylinder.
Press and hold electronic ignitor
button. "Click" should be heard and spark seen each time
between collector box or burner and electrode. See
"Troubleshooting"
if no click or spark.
Valve Check
• Important: Make sure gas is off at LP cylinder before
checking valves
. Knobs lock in
position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to
LOW
position then turn back to
position. Valves should turn smoothly.
Hose Check
•
Before each use, check to see if hoses are cut or worn.
Replace damaged hoses assembly before using grill. Use only
valve/hose assembly specified by manufacturer.
OFF
OFF
OFF
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Turn controls and gas source or tank OFF when not
in use.
WARNING
Match-Lighting
s
Do not lean over grill while lighting.
1.
2. Open lid.
Turn on gas at LP cylinder.
3.
Place lit match into match holder (hanging from cart side
panel), then into lighting hole on right or left side of grill.
4.
Push in and turn far right or far left burner knob to HIGH .
Be sure burner lights and stays lit.
5.
Light adjacent burners in sequence by pushing knobs in and
turning to HIGH .
Turn
OFF
all burner control valves.
Side Burner Lighting Instructions:
s
Do not lean over grill while lighting.
1. Turn
OFF
all gas burner control valves.
2. Turn
ON
gas source or tank.
3. Open lid during lighting.
4. To ignite SIDEBURNER, turn sideburner knob to the
position.
5. Push and hold the ELECTRONIC IGNITOR button untill the
sideburner lights.
6. Once burner has ignited, turn knob to desired setting.
7 If ignition does not occur in 5 seconds, turn the burner control
to OFF, wait 5 minutes, and repeat the lighting procedure.
Sideburner Match Lighting
1.
2. Open sideburner lid. Turn on
gas at LP cylinder.
3. Place lit match near burner.
4. Turn sideburner knob to
HIGH . Be sure burner
lights and stays lit.
Turn
OFF
all burner control valves.
