Chaparral 246 SSI 2019, Owner'S/Operator'S Manual

Page: 67 / 83

2019 246 SSI SPORT BOAT
Chaparral Boats, Inc.
chaparralboats.com
Hull Bottom Maintenance
If your boat will be in water continuously for more than 60 days in any
90‐day period, Chaparral recommends sealing the hull bottom with a
high quality barrier coating. Failure to do so will void your hull blister
warranty. Your Chaparral dealer can recommend the best barrier
coating product for your boat.
Never use wire brushes, scouring pads, or other abrasive materials or
solutions on the bottom surface of your boat. They cause small scratch
marks that will collect dirt, silt, sand, marine growth and other foreign
materials.
Keep the hull bottom of your boat clean. Check it regularly for any signs
of excessive wear or damage. Make needed repairs to the hull bottom as
soon as possible. Accumulation of natural coatings from water and
marine growth can create drag and limit the efficiency of your boat.
Bottom Paint (Anti ‐ Fouling)
Important: Consult your Chaparral dealer for recommended bottom
paints and local laws that govern your area. Many states regulate the
chemical content of bottom paints to meet environmental standards
and regulations.
Anti‐fouling bottom paint is designed to prevent marine growth by
dissolving slowly. As a result, the bottom of your boat will usually need
painting after the boating season. Some variables to consider when
selecting a protective bottom paint are the water temperature, water
pollution, salinity, current, and organic matter in the water. To protect
and repaint the boat bottom, perform the following:

Remove boat from water once a year. Scrub bottom with a soap
and water solution and a bristled brush.
Note: Repainting the bottom is not necessary each time the bottom
is scrubbed, as long as no bare areas are visible in the bottom paint.

Sand entire bottom surface of the boat.

Fair (smooth out) all rough areas as required.

Clean bottom surface to remove all dust and foreign materials.

Make sure bottom surface is completely dry.

Apply new coat of bottom paint.
Allow new bottom paint to dry 24 to 36 hours. Never attempt to haul,
paint, and launch on the same day.
Hardware and Fittings
Note: Always follow the manufacturer’s recommendations found in
your owner’s packet for cleaning and maintaining deck hardware
and fittings. These recommendations include the proper cleaning
methods and cleaning agents.
Inspection
Inspect hardware and fittings to make sure they are tight. All screws,
bolts, clamps, cleats, etc., should be secure.
Cleaning and Care

Always clean stainless steel frequently with soap and water. Any
cleaner safe for glass is usually safe for stainless steel.

Always remove rust spots as soon as possible with a brass, silver,
or chrome cleaner. Irreversible pitting will develop under rust
that remains on stainless steel for any period of time.

Always use a cleaner, like a good car wax, for added beauty and
protection.
 Never use coarse abrasives like sandpaper or steel wool on
stainless steel. These may actually cause rusting.

Never clean with mineral acids or bleaches.

Never leave stainless steel in contact with iron, steel, or other
metals which cause contamination leading to rust or corrosion.
63
https://www.boat-manuals.com/