8 | P a g e
SW: Software version; HW: Hardware version
Options of factory default setting
：
8VSB (ATSC) / B-64 (Annex B, 64QAM) / B-256 (Annex B, 256QAM)
Factory default is B-64
3-2-9. Save Changes
•
Display will return to the upper menu after saving the changes.
Any change of the configuration will not take effect after restarting the system if it is
not saved, all the settings will be reset to the factory defaults.
All the saved values will be stored in the memory until next value saved. (none volatile memory)
3-3. Configure through web
Set an IP address of the modulator from the front panel if you don’t want to use the default IP address.
Connect the modulator to the computer through RJ45 cable.
Enter the IP address of the modulator (Default address: 192.168.1.145) Internet Explorer browser
Press <Update> after changing settings in each category. Go to SAFE page to save the
configurations.
Configure network settings with existing network
•
Locate your computer network configuration address information on the following page 1-2 & 1-3.
•
Enter this information into the front panel.
1.Preset 8VSB
2.Preset B-64
3.Preset B-256
6.2. Factory set.
Save Values
Please wait....
7. Save changes
