Champion WheelyBird Instruction Manual Download

Page: 2 / 15

Table of Contents

Section

Page

I. Introduction / FCC Notice ..................................................

II. Safety ...............................................................................

III. Contents ..........................................................................

IV. Features and Descriptions ..............................................

V. Programming ...................................................................

VI. Installation ......................................................................

VII. Operation ......................................................................

VIII. Troubleshooting ...........................................................

Warranty and Contact Information ......................................

I. Introduction

Congratulations on the purchase of your new Champion

WheelyBird™/Workhorse

Wireless Remote.

This Champion

Wireless Remote is an optional accessory for use with Champion Workhorse and Post 2017 WheelyBird

Traps with removable foot pedal.

Features of the Champion

Wireless Remote Release system include:

* Battery powered hand-held remote, high impact plastic case

* Up to 120 yd transmission range

* Single Release system that will work with multiple receiver units

* User settable delay from 0-15 seconds

* Quick and easy installation

FCC NOTE:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired

operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Shielded interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of

FCC Rules.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate

this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Radiation Exposure Statement:

The product complies with the FCC portable RF exposure limit set forth for an uncontrolled environment and is safe for the intended operation as

described in this manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user ‘s body or when

set to lower output power if such function is available.

Industry Canada Statement

This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause

interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Radiation Exposure Statement:

This device complies with the Industry Canada portable RF exposure limit set forth for an uncontrolled environment and is safe for the intended

operation as described in this manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user’s

body or if the device is set to a lower output power if such function is available.