![background image](http://html.mh-extra.com/html/champion/u-h1/u-h1_technical-manual_2588549015.webp)
INITIAL START-UP
After plumbing and electrical connections are completed,
follow the steps below to place your machine in service.
Model U-H1 and U-HB
1.
Remove any foreign material from inside the machine.
Make sure filter, and drain-overflow tube are in place.
2.
Close the Door.
3.
Turn the water and main power sources to the dishwasher ON.
4
Flip the Power switch to the ON position. The red “power on” light will illuminate and the
machine will automatically fill with water.
5.
Check the machine for leaks.
6.
Push the Green Start Button to check automatic cycle. Check for leaks.
7.
If machine checks okay, remove the drain-overflow tube to drain machine.
8.
Flip the power switch to OFF.
Model U-LD
1.
Remove any foreign material from inside the machine. Make sure filter, is in place.
2.
Close the Door.
3.
Turn the water and main power sources to the dishwasher ON.
4
Flip the Power switch to the ON position. The red “power on” light will illuminate.
5.
Hold the Fill switch in the “UP” position for about 45 sec. to fill the machine with water.
Machine is full when water level reaches drain overflow located at lower left rear corner
of wash tank interior.
6.
Check the machine for leaks.
7.
Prime the chemical dispensing pumps.
NOTE:
The pick-up tubes are color coded:
Red = detergent Blue = rinse aid Clear = sanitizer
8.
Insert the pick-up tubes in the appropriate chemical containers.
9.
Open the door of the machine.
10.
Hold each of the three prime switches, located on the front of the control cabinet in the
“UP” position until you see chemical enter the tank interior from all three tubes.
NOTE:
The chemical tubes discharge point is on the right side of the wash tank ceiling.
11.
The chemical dispensing system will work automatically until the chemical supply is
used up. Re-prime the dispensing pump after replacing a chemical container.
12.
Close the door.
13.
Push the the Green start button to check the automatic cycle. Check for leaks.
14.
If machine checks okay, hold the drain switch in the “UP” position
until machine drains completely.
15.
Flip the power switch to OFF.
13
INITIAL START-UP
Summary of Contents for U-H1
Page 6: ...4 NOTES NOTES ...
Page 58: ...56 REPLACEMENT PARTS Figure 25 Dishracks Strainer PRV 1 2 3 4 ...
Page 63: ......
Page 64: ......