![background image](http://html.mh-extra.com/html/champion/easybird-40913/easybird-40913_instruction-manual_2588645015.webp)
If you require parts or service assistance, please call the
CHAMPION TRAPS & TARGETS Customer Service Dept.
at (800) 379-1732
©
2015 CHAMPION TRAPS & TARGETS, Anoka, MN 55303
13
VI. Troubleshooting
I.
THE MOTOR DOES NOT RUN
1. The “ON-OFF” switch on the Oscillating Base is in the “OFF” position.
2. The circuit breaker is tripped - determine cause before resetting.
3. Battery is inadequately charged - recharge battery.
4. Electrical connections are loose or damaged.
5. The motor is burned out.
6. The base is blocked from rotating, or the lock down nut is tight.
II.
THE MOTOR RUNS, BUT THE BASE DOES NOT OSCILLATE
1. The drive linkage bar is disconnected or the linkage bar mounting bolt is broken –
check and replace as necessary.
2. Drive belt is loose, broken, or the gear motor mounting bolts are loose – Retighten
mounting bolts or replace drive belt.
VII. Maintenance
WARNING: BEFORE PERFORMING ANY MAINTENANCE ON ANY EASYBIRD TRAPS
MAKE SURE THAT THE THROWING ARM IS IN THE UNCOCKED POSITION (SEE
FIGURE 3), THE ON/OFF/SAFE RELEASE SWITCH IS IN THE “OFF” POSITION AND THE
BATTERY HAS BEEN DISCONNECTED.
Preventive Maintenance Action
Frequency
Remove dust, dirt, and target debris with soft brush
Before every use
Check mounting bolts to insure they remain tight
Every month or 8,000 cycles
Lubricate moving parts with a good quality Teflon
Every month or 8,000 cycles
based lubricating oil such as OUTERS Tri-Lube
Disconnect Battery
After Every use
Check condition of oscillating base drive belt
Every month or 8,000 cycles
VIII. Recommended Spare Parts
QTY
PART NO.
DESCRIPTION
LOCATION
1
45311
Oscillating Base Drive Belt
Page 5, L-5
ORDERING PARTS
Parts can be ordered through the Champion Traps & Targets Customer Service Dept.
at (800) 379-1732.
Prices are subject to change without notification. Minimum order value of $10.00