D6.D7.5-MANS
Mar ’19
- 21 -
‘CSC50’ Controller
Description of Controller
The ‘CSC50’ Controller is the ‘brains’ of the D6 and D7.5 series Rotary Screw Compressor Units. It monitors,
enables, and indicates the various functions of the Unit.
The Controller is comprised of two levels of access, segregated into:
-
Level 1 or ‘Operational Menu’
:
- allowing access to the most commonly used parameters
-
Level 2 or ‘Configuration Menu’
:
- is more suited to Service Technicians, and allows access to all parameters
Codes are required to access these levels of the Controller, this to ensure that the Unit variables are not altered in
error.
Controller Operator Interface
The Operator Interface for the ‘CSC50’ Controller is shown below.
Description of Interface
1. Main Display Value (0.1 to 999)
2. Main Display Value Units (°C, °F, Bar, PSI)
3. User Menu Item Display Value (0.1 to 99999)
4. User Menu Item Display Value Units (°C, °F, Bar, PSI)
5. Status Symbols
= Started
= Running
= Loaded
6. Service / Fault Symbols
= Service
= Fault: Alarm
Required
Warning / Trip
Start
Allows the Unit to begin
compressing air.
Up
Scrolls forwards
through the
parameters, or can
be used to increase
the value of a
parameter.
Stop
Causes the Unit to enter ‘Idle’
mode and then shut off.
Down
Scrolls backwards
through the
parameters, or can
be used to decrease
the value of a
parameter.
Reset
Allows the Unit to
be re-started after
an error has
occurred.
Emergency Stop
(if equipped)
Will quickly shut off
the Unit. Is only to
be used in an
emergency.
Enter
Must be pressed to save
changes to a parameter.