EN
2
Parts
1. Lid
2. Spout
3. Body
4. Power base
5. Lid button
6. Handle
7. Water level gauge
8. Power switch
5
7
6
8
3
4
2
1
Before using your kettle
If you are using the kettle for the first time, it is recommended that you should clean your kettle before use by
boiling the Max capacity of water once and then discarding the water twice. Wipe the surface with a damp cloth.
NOTE:
The max capacity of kettle is 1.7L.
Use
1. Place the kettle on the flat surface.
2. To fill the kettle, remove it from the power base and open the lid by pressing down lid
release button, then fill the kettle with the desired amount of water and close the lid. The water level must be
within the Min and the Max level. Too little water will cause the kettle switching off before the water has boiled.
NOTE:
Do not fill the water over the maximum level, as water may spill out of the spout when
boiling. Ensure that the lid is firmly in place before plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the switch and the indicator will light up, and then the kettle
starts to boil the water. The kettle will switch off automatically once the water has boiled. If necessary, it will
take you 30 seconds to wait before pressing the switch again to re-boil the water. You may shut off the power
by lifting switch up or directly lift the kettle from the power base at any moment to stop boiling process.
NOTE:
Ensure that switch is free of obstructions and the lid is firmly closed, the kettle will not
turn off if the switch if be constrained or if the lid is opening.
5. Lift the kettle from the power base and then pour the water.
NOTE:
Operate carefully when pouring the water from your kettle as boiling water may result
in scald, besides, don’t open the lid while the water in the kettle is hot.
6. The kettle will not re-boil until the switch is pressed again. The kettle may be stored on the power base when
not in use.
NOTE:
Always disconnect the power supply when not use.