![background image](http://html1.mh-extra.com/html/champion/chsm210/chsm210_user-manual_2588965006.webp)
5
EN
5.
It will take approximately 25 seconds for preheating to finish. Once the steam mop is ready
to use the water tank will glow blue.
6.
When the water tank is full of water, the steam mop can work for approximately 20 minutes.
If the water tank (7) is without water, the indicator light (12) will glow red, and the lights will
flash to point out the need to add water.
NOTICE:
If powered off during preheating or after preheating, then powered on again, the
appliance will repeat above preheating action.
7.
Press the steam button (4) and steam button (13).
8.
Add control volume by turn steam control knob (8) clockwise, and counterclockwise to
reduce.
NOTICE
:
It will take approx. 3 seconds adaptation time when you adjust steam volume.
Use as hand held steam cleaner
1. Press handle tube button to remove the handle from
main body (A).
2. Install the accessory adaptor at the top of main body
(A), until it into place.
3. Press salient point at the accessory adaptor to re-
move the accessory adaptor from main body (A).
4. Choose the appropriate accessory (check access-
ories use list) according to arrow indicator to align
and implant to accessory adaptor (G). Turn antic-
lockwise, until it fits into place.
Trouble shooting
Use troubleshooting guide as a first step to resolve any problems you may be experiencing. All
service should be done by an authorized service representative.
! Warning
To reduce risk of personal injury-unplug steamer before servicing and allow to cool
Problem
Possible Reason
Possible Solution
Reduced steam or no steam
1. Water tank may be empty
2. Steam nozzle may be block-
ed
3. There is no power to the unit
4. Didn’t press steam button
5. Steam control Knob is at
MIN
1. Fill water into the water tank
2. Clean steam nozzle
3. Make sure unit is plugged in
4. Press steam button
5. Turn steam control knob
clockwise
Unit will not turn on
1. Blown fuse or breaker
2. Power cord not plugged in
3. Internal fuse is blown
1. Replace fuse or reset brea-
ker in home
2. Plug cord into a working
circuit
3. Contact with customer ser-
vice