REV 93020-20120419
18
93020
ENGLISH
MAINTENANCE ANd STORAGE
DO NOT use a garden hose to clean the engine or
log splitter .
CAUTION
Water can contaminate the fuel system and can
enter the engine through the cooling slots and
damage the engine .
Maintenance Schedule
Follow the service intervals indicated in the schedule
below . Service your log splitter more frequently when
operating in adverse conditions . Contact our help line at
1-877-338-0999 to locate the nearest Champion Power
Equipment authorized service dealer for your log splitter
or engine maintenance needs .
*To be performed by knowledgeable, experienced owners or
Champion Power Equipment certified dealers .
Every 8 hours or daily
Check engine and hydraulic oil levels
Clean around air intake and muffler
First 5 Hours
Change engine oil
Every 50 hours or every season
Clean air filter
Change engine oil if operating under heavy load or in
hot environments
Every 100 hours or every season
Change engine oil
Clean/Adjust spark plug
Check/Adjust valve clearance *
Clean fuel tank and filter *
Change hydraulic oil
Change hydraulic oil filter
Every 250 hours
Clean combustion chamber*
Every year
Inspect wheel bearings and repack bearing grease as needed .
Every 3 years
Replace fuel line
Cleaning
Clear the debris from the beam, wedge and end plate .
Use a damp cloth to clean exterior surfaces of the engine
and log splitter .
Use a soft bristle brush to remove excess dirt and oil . Use
an air compressor (25 PSI) to clear dirt and small debris .
Wipe all metal parts with an oily rag to help prevent rust
and corrosion .
Storage
Refer to the Maintenance section for proper cleaning
instructions .
Log Splitter Storage
1 . The log splitter needs to be cool for at least 5
minutes before storing .
2 . Clean the log splitter before storage according to the
Maintenance section .
3 . Retract the wedge to protect the rod from corrosion .
4 . Wipe the beam and wedge with an oily rag to
prevent rust and corrosion .
Engine Stored for Less than 30 days
1 . Allow the engine to cool completely before storage .
2 . Clean engine according to the Maintenance section .
3 . To extend the fuel storage life add fuel stabilizer .
4 . Turn the fuel valve to the off position .
Engines Stored for Over 30 days
1 . Run the engine with the fuel valve in the “Off”
position until the engine stops .
2 . The engine needs to cool completely before storage .
3 . Clean engine according to the Maintenance section .
4 . Drain all fuel completely from the fuel line and
carburetor to prevent gum from forming .
5 . Add a fuel stabilizer into the fuel tank .
6 . Change the oil .
7 . The fuel valve needs to be in the off position .
8 . Remove the spark plug and pour about 1⁄2 ounce
of oil into the cylinder . Crank the engine slowly to
distribute the oil and lubricate the cylinder .
9 . Reattach the spark plug .
Never store the log splitter inside next to appliances
where there is a source of heat or open flame, spark
or pilot light because they can ignite gasoline vapors .
DO NOT store a log splitter near fertilizer or any
corrosive material .
Even with an empty gas tank, gasoline vapors could
ignite .
WARNING
