![background image](http://html1.mh-extra.com/html/champion/64022/64022_owners-manual-and-operating-instructions_2589006011.webp)
Assembly
Rev 64022-20100514 E
7
Assembly
Your semi-trash pump requires some
assembly. This unit ships from our factory
without oil. It must be properly serviced
with fuel and oil before operation.
If you have any questions regarding the
assembly of your semi-trash pump, call our
help line at 1-877-338-0999. Please have
your serial number and model number
available.
Remove the Semi-trash pump
from the Shipping Carton
1.
Set the shipping carton on a solid, flat
surface.
2.
Remove everything from the carton
except the semi-trash pump.
3.
Carefully cut each corner of the box
from top to bottom. Fold each side flat
on the ground.
Install the Wheel Kit
CAUTION
The wheel kit is not intended for over-the-road
use.
You will need the following tools to install
the wheels: (not included)
12 mm wrench
Socket wrench with a 12 mm socket
1.
Slide the M8x75 wheel bolt through the
washer, sleeve and wheel.
2.
Slide the bolt through the mount point
on the frame.
3.
Fasten securely with the M8 nut.
4.
Repeat steps 1-3 to attach the second
wheel.
Install the Vibration Mounts
1.
Attach the two rubber vibration mounts
to the frame cross member with a cap
screw (M8x25) and lock nut (M8).
2.
Tip the semi-trash pump slowly so that
it rests on the wheels and vibration
mounts.
Install the Handle
1.
Line up the holes at the base of the
handle with the receiving holes on the
semi-trash pump frame.
2.
Thread cap screws (M8x45) through the
frame and handle.
3.
Place a lock nut (M8) on the end of the
cap screw and fasten securely. DO NOT
over tighten the lock nut.
Add Engine Oil
CAUTION
DO NOT attempt to crank or start the engine
before it has been properly filled with the
recommended type and amount of oil. Damage
to the semi-trash pump as a result of failure to
follow these instructions will void your warranty.
1.
Place the semi-trash pump on a flat,
level surface.
2.
Remove oil fill cap/dipstick to add oil.
3.
Add 0.63 qt (0.6 L) of oil and replace oil
fill cap/dipstick.
4.
Check engine oil level daily and add as
needed.
CAUTION
The engine is equipped with a low-oil-shutoff and
will stop when the oil level in the crankcase falls
below the threshold level.
Summary of Contents for 64022
Page 2: ......
Page 4: ......
Page 20: ...Specifications 16 Rev 64022 20100514 E Parts Diagram...
Page 22: ...Specifications 18 Rev 64022 20100514 E Engine Parts Diagram...