REV 46555-20110708
8
46555
ENGLISH
Your generator requires some assembly . This unit ships
from our factory without oil . It must be properly serviced
with fuel and oil before operation .
If you have any questions regarding the assembly of your
generator, call our help line at 1 (877) 338-0999 . Please
have your serial number and model number available .
Remove the Generator from the Shipping Carton
1 . Set the shipping carton on a solid, flat surface .
2 . Remove everything from the carton except the
generator .
3 . Carefully cut each corner of the box from top to
bottom . Fold each side flat on the ground to provide a
surface area to install the wheel kit and support leg .
Install the Wheel Kit
You will need the following tools to install the wheels:
• 17 mm wrench OR adjustable wrench (not included)
• Socket wrench with a 16 mm socket (not included)
• Pliers (not included)
1 . Before adding fuel and oil, tip the generator on it’s side .
2 . Slide the wheel bolt (M10x105) through the washer,
sleeve and wheel .
3 . Slide the bolt through the mount point on the frame .
4 . Fasten securely with the M10 nut .
5 . Repeat steps 2-4 to attach the second wheel .
Install the Support Leg
1 . Attach the support leg to the generator frame with
cap screws (M8x16) and lock nuts (M8) .
2 . Tip the generator slowly so that it rests on the
wheels and support leg .
The wheel kit is not intended for over-the-road use .
CAUTION
ASSEMBLy
Connect the Battery
1 . Remove the protective cover from the red (+) lead on
the battery .
2 . Attach the red (+)lead to the red (+) terminal on the
battery with the cap screw (M6x10) and secure with
the lock washer (M6)
3 . Repeat steps 1-2 for the black (–) battery lead .
The recommended oil type is 10W-30 4-cycle
automotive oil .
NOTE
Add Engine Oil
DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
type and amount of oil . Damage to the generator as
a result of failure to follow these instructions will
void your warranty .
CAUTION
