13
Instaillation
Electrical Connections
WARNING:
There may be more than one power source connected to the machine.
Make sure all power sources are disconnected, locked and tagged out
before working on the machine.
Electrocution may occur when working on energized circuits. Disconnect
power at the main breaker or service disconnect switch, then lock out and
tag it to indicate that work is being performed on the circuit.
The installation of the dishwasher must comply with all local electrical, plumbing,
health and safety codes or in the absence of local codes, installed in accordance
with the applicable requirements in the National Electrical Code, NFPA 70,
Canadian Electrical Code (CEC), Part 1, CSA C22.1; and the Standard for Vent-
ilation Control and Fire Protection of Commercial Cooking Operations, NFPA 96.
CAUTION:
Only qualified personnel familiar with the installation of food service equipment should attempt the installation
of this machine. Damage or problems associated with improper installation will not be covered by the dishwasher
limited warranty.
! ATTENTION INSTALLER !
All machines are shipped from the factory as a 1-POINT
connection. The BOOSTER is wired for 21kW operation.
IT IS THE INSTALLER’S RESPONSIBILITY TO CHANGE
THE CONNECTION TO 2-POINT
AND/OR THE BOOSTER TO 12kW IF REQUIRED.
