100544 - 7000W DUAL FUEL GENERATOR
OPERATION
21
4. Once engine starts, move choke lever to the “RUN”
position
P
.
"
NOTICE
Keep choke in “CHOKE” position for only 1 pull of the recoil
starter. After first pull, move choke to the “RUN” position for
up to the next 3 pulls of the recoil starter. Too much choke
leads to spark plug fouling/engine flooding due to the lack of
incoming air. This will cause the engine not to start.
"
NOTICE
For gasoline restarts with hot engine in hot ambient > 30°C
(86°F), keep the choke in 75% of the “CHOKE” position for
only 1 pull of the recoil starter. After first pull, move choke
to the “RUN” position for up to 3 more pulls of the recoil
starter. Too much choke leads to spark plug fouling/engine
flooding due to the lack of incoming air. This will cause the
engine not to start.
"
NOTICE
For gas starting in cold ambient <15°C (59°F) the choke
must be in 100% of the “CHOKE” position for recoil start
procedures. Do not over-choke. As soon as engine starts,
gradually move the choke lever to the “RUN” position over a
2-5 second duration.
Starting the Engine: Propane (LPG)
1. Refer to Generator Location section before attempting to
start generator.
2. Make certain the generator is filled with oil. See Assembly
section.
3. Make certain the generator is on a level surface.
4. Connect LPG cylinder. See page 18 – Add Fuel: Propane
(LPG)
5. Fully open fuel valve on propane cylinder.
6. On the side operator panel, rotate the fuel selector dial to
PROPANE.
iLINK™ App Start
(see iLINK™ Wireless App section (pg 24)
for details on set-up and first use)
1. Press the START/STOP button once. The button will flash
amber.
2. Start app on smart device and follow instructions.
3. Press START on app screen. The generator will attempt to
start. There will be (4) starting attempts.
Electric Start
1. Disconnect all electrical loads from the generator. Never
start or stop the generator with electrical devices plugged
in and turned ON.
2. Press the START/STOP button once. The button will flash
amber but the generator will not attempt to start.
3. Press the START/STOP button a second time. The button
will now flash green and the generator will attempt to start.
There will be up to (4) starting attempts. After generator
starts, the button will turn solid green.
Manual Start
1. Disconnect all electrical loads from the generator. Never
start or stop the generator with electrical devices plugged
in and turned ON.
2. Move choke lever to the “CHOKE” position
O
if starting
cold or warm engine.
3. Pull the starter cord slowly until resistance is felt and then
pull rapidly. Several pulls may be required.
4. Once engine starts, move choke lever to the “RUN”
position
P
.
"
NOTICE
Manual start on LPG will only work if there is gasoline in the
carburetor.
