![background image](http://html1.mh-extra.com/html/champion/100192/100192_owners-manual_2589005016.webp)
13
ENGLISH
100192
MAINTENANCE AND STORAGE
Adjustments
The air-fuel mixture is not adjustable. Tampering with
the governor can damage your chemical pump and
your electrical devices and will void your warranty. CPE
recommends that you contact our service line at
1-877-338-0999
for all other service and/or adjustment
needs.
Maintenance Schedule
Follow the service intervals indicated in the following
maintenance schedule.
Service your chemical pump more frequently when
operating in adverse conditions.
Contact our help line at
1-877-338-0999
to locate the
nearest Champion Power Equipment certified service dealer
for your chemical pump or engine maintenance needs.
*To be performed by knowledgeable, experienced owners or
Champion Power Equipment certified dealers.
Use a damp cloth to clean exterior surfaces of the engine.
Use a soft bristle brush to remove dirt and oil.
Use an air compressor (25 PSI) to clear dirt and debris
from the engine.
Cleaning
DO NOT spray engine with water.
CAUTION
Water can contaminate the fuel system.
Every 8 hours or daily
Check oil level
Clean around air intake and muffler
First 5 Hours
Change oil
Every 50 hours or every season
Clean air filter
Change oil if operating under heavy load or in hot
environments
Every 100 hours or every season
Change oil
Clean/Adjust spark plug
Check/Adjust valve clearance*
Clean spark arrester
Clean fuel tank and filter*
Every 250 hours
Clean combustion chamber*
Every 3 years
Replace fuel line
Storage
For short and long-term storage, please follow these
guidelines.
Flushing the Pump
Flush the pump with clean water after each use is
advised. This will help to extend the life of the pump as
some materials pumped may leave residue that could
corrode parts, build up over time, or cause harm to any
plants, animals or humans. Flushing the pump will help
to reduce any damage and dangers caused by pumping
chemicals and pesticides.
Drain Plug
Make sure to unscrew and use the drain plug after each
use. By draining the pump, this will help to ensure little
to no water is left in the pump and will help prevent
damage to the pump if water residue freezes. DO NOT
use the Drain Plug during pump operation, as this may
cause injury or death.
Engine switch should be in the “OFF” position while pulling
the recoil cord, and performing storage maintenance steps.
NOTE
Engine Stored for Less than 30 Days
1. Allow the engine to cool completely before storage.
2. Clean engine according to the Maintenance section.
3. To extend the fuel storage life add a properly
formulated fuel stabilizer to the tank.
4. Ensure the fuel valve is in the “OFF” position.
Engine Stored for Over 30 Days
1. Add a properly formulated fuel stabilizer to the tank.
2. Run the engine for a few minutes so the treated fuel
cycles through the fuel system and carburetor.
3. Turn the fuel valve to the “Off” position.
4. Let the engine run until fuel starvation has stopped
the engine. This usually takes a few minutes.
5. The engine needs to cool completely before cleaning
and storage.
6. Clean the engine according to the maintenance section.
7. Change the oil.
8. Remove the spark plug and pour about 1⁄2 ounce
(14.8 ml) of oil into the cylinder. Crank the engine
slowly to distribute the oil and lubricate the cylinder.
9. Reattach the spark plug.