Champion Power Equipment 92208, Owner'S Manual And Operating Instructions

Page: 13 / 28

REV 92208-20120717
10
92208 ENGLISH
OPERATION
Before Each Use Inspect the Log Splitter
1 . Check the hydraulic oil level and visually inspect all
hoses, attachments and cylinder for leaks, cracks,
fraying or other damage .
2 . DO NOT operate the log splitter if there is any
indication of damage or oily residue .
3 . Inspect the engine and make sure the oil level is
correct before operating . If the engine is equipped
with a spark arrestor, clean and inspect it regularly
(follow spark arrestor maintenance schedule) .
4 . The tires need to be fully inflated and in good repair .
Reference the tire sidewall for recommended tire
pressure .
Towing Log Splitter Safety
1 . Always check local and state regulations regarding the
requirements for towing, licensing and lights .
2 . Before towing make sure the log splitter is correctly
and securely attached to the vehicle and the safety
chains attached with enough slack to allow for turning .
3 . Never exceed the max . travel speed of 72 km/h (45
MPH) . Towing the log splitter at speeds greater than
72 km/h (45 MPH) could result in serious injury or
death . Always adjust your towing speed according to
the terrain and conditions .
4 . Always disconnect the log splitter from the towing
vehicle before operating .
Log Splitter Location
This log splitter must have at least 2 .1 m (7 ft .) of
clearance from combustible material . Leave at least 91 .4
cm (3 ft .) of clearance on all sides of the log splitter to
allow for adequate cooling, maintenance and servicing .
DO NOT place the log splitter near vents or intakes where
engine exhaust fumes could be drawn into occupied or
confined spaces .
Always operate the log splitter outdoors.
The log splitter needs to be on a dry, level surface with
good footing . DO NOT work on mud, ice, tall grass, brush
or snow .
Only operate log splitter from work zone shown below .
Vertical Operating
Position
Work Zone
Horizontal Operating
Position
Wo
rk
Zo
ne
Log Splitter Location Cont’d.
For Vertical Operation:
– Remove the beam lock-pin from the beam
bracket
– Use handle on cylinder to rotate beam to vertical
position
– Insert beam lock-pin in the pivot bracket
NOTE
DO NOT overinflate tires . Serious injury can result if
tires explode .
DO NOT tow the log splitter if the tires are worn or
will not hold air .
DO NOT exceed the maximum 72 km/h (45 MPH)
towing speed .
WARNING