15
100624 - 9 TON FULL BEAM LOg SPLiTTER
ASSEMBLY
ASSEMBLY
If your log splitter is already assembled, skip the assembly
instructions in this manual.
If unassembled, please read and follow these instructions.
If you have any questions regarding the assembly of your log
splitter, call our Technical Support Team at 1-877-338-0999.
Please have your serial number and model number available.
Open Shipping Crate
1. Set the shipping crate on a solid, flat surface.
2. Carefully cut the shipping bands and remove lid of shipping
crate.
3. Locate all hardware before beginning assembly.
install the Wheels
1. Slide the wheel onto the axle.
2. Install the washer (38) and cotter pin (39) through the axle.
38
39
install the Support Leg
1. Place the beam on a flat, level surface resting on the wedge
and cylinder brackets.
2. Align the support leg (28) with the mounting holes on the
beam bracket.
3. Place the M8×25 bolt (24) through the hole.
4. Place a Ø8 washer (27) and Ø8 lock washer (26) on the end
of the bolt.
5. Install the M8 nut (25) on the bolt and tighten. Do not over
tighten.
24
28
27
26
25
install the Beam
1. With the beam still resting on the wedge and cylinder
brackets, align the 4 larger holes on the wheel mount base
plate with the threaded blocks on the beam.
2. Thread an M10×20 bolt (34) through a Ø10 washer (22).
3. Thread the bolt and washer through the hole on the base
plate and into the threaded blocks on the beam and tighten
4. Repeat steps 1-3 for the remaining 3 bolt and washer sets to
complete the mounting of the beam to the wheel mount.
5. Once all bolts are tightened, flip the assembly over to rest on
the wheels and support leg.
NOTiCE
The beam should extend to the opposite side of the wheel
mounts as shown.
WARNiNg
The beam is extremely heavy and should only be handled
with 2 or more people. DO NOT try and lift or handle the beam
without assistance.
3 pt
34
22
500887
