11
ENGLISH
100398
ASSEMBLY
Hybrid Mount Polaris
®
Sportsman
®
Install
1 . Measure the thickness of your tube frame and skid
plate (if installed), see Figure 23 . Then cut the
provided rubber spacers to a
1
⁄
4
in . (6 .4 mm) longer
then the thickness of the tube frame .
If there is a skid plate installed and you do not wish
to remove it, you will need to mark the locations
where the bolts will be installed and drill holes .
NOTE
Figure 25 - Hybrid Mount Sportsman Install
FRONT
5.4
1
2
5.3
5.2
5.5
4
3
Figure 23 - Frame Measurement
Figure 24 - Fastener Placement
1
2
3
4
FRONT
FRONT
ACCEPTABLE
INCORRECT
RECOMMENDED
FRONT
2 . Place the upper mount plate
(2)
over the frame at
the location behind the tires where the frame widens
out . Refer to Figure 24 for best fastener placement .
3 . Determine the location allowing the mount to be
centered, back as far on the frame as possible and
the push tubes to be attached . Keep the mount holes
within the approximate distance (26 in . {66 cm})
from the front of your machine . See page 8,
Figure 16 .
4 . Loosely install the upper mount plate
(2)
, 4 spacer
plates
(3)
and lower mount plate
(1)
using the rubber
spacers
(4)
,
3
⁄
8
in . (9 .5 mm) bolts
(5.4)
,
3
⁄
8
in .
(9 .5 mm) carriage bolt
(5.5)
, nuts
(5.2)
and washers
(5.3)
provided with your mount . See Figure 25 .
5 . Tighten all bolts evenly . Carriage bolt only needs
to be snug to plate as its purpose is to keep both
plates from bending in the center .
Hybrid Mount Polaris
®
Sportsman
®
Install Cont’d.
Ensure that the rubber spacers are tight against the
frame before tightening the bolts . If this is done
incorrectly the mount could move and the plow may
damage your machine .
NOTE