100380 - REAR TiNE TiLLER
ASSEMbLY
14
ASSEMbLY
Your tiller requires some assembly. This unit ships from our
factory without oil. It must be properly serviced with fuel and oil
before operation.
If you have any questions regarding the assembly of your tiller,
call our Technical Support Team at 1-877-338-0999. Please
have your serial number and model number available.
Unpacking
1. Remove all parts and packaging components.
2. Remove top lid and remove sides.
3. Remove any remaining packaging.
4. With helper, remove the tiller from the shipping crate.
Attach Lower Handle
1. Loosen the lower handle bolts.
2. Align the lower handle holes to the middle height
adjustment holes in the transmission cover and install
the (4) M10×25 mm flange head bolts and (4) M10 nuts.
Tighten all hardware.
install the Wheels
1. Remove the locking pins from the wheel hubs.
2. The tiller wheels are directional. For best performance
install the wheels with the tire thread facing the direction
as shown.
3. Slide the wheel hub onto the wheel axle.
4. Align the wheel hub hole with the hole in the axle and
insert the locking pin.
5. Rotate the locking pin ring to lock the pin in position.
Repeat on other wheel.
install the Tines
Before assembly
1. Check the orientation of the tine blade. The sharp cutting
edge should be facing the direction of tine rotation for your
tiller.
2. Install the tine assemblies on each tine axle. Secure with
(2) pins and (2) cotter pins. Bend cotter pins once inserted
to prevent them from coming out.
after assembly