100380 - REAR TiNE TiLLER
ASSEMbLY
15
install the Tine Shield
1. Remove the (4) M10×25 mm flange head bolts installed in
the tine shield brackets above the transmission housing.
2. Place the tine shield on the bracket and secure with the
bolts removed in step 1.
install the Depth Regulator
1. Remove the (1) pin and (1) clip from the depth regulator
lever.
2. Insert the depth regulator into the bottom of the depth
regulator bracket.
3. Insert the pin through the bracket and lever.
4. Install the clip removed in 1 onto the depth regulator lever.
Attach Upper Handle
1. Slide the upper handle down over the lower handle and
align the holes.
2. Insert the (4) M8×50 curved head bolts into the holes as
shown and securely with the (4) handle knobs and (4) flat
washers.
3. Tighten the handle knobs securely.
Attach Speed Control
1. Attach speed control using provided (1) M6 bolt, (1)
washer, and (1) M6 nut.
2. Tighten completely.
3. Use plastic clips to secure the cables as shown.
Attach front bumper
1. Slide the front bumper onto the outside of the base frame
and align the holes.
2. Install the (4) M8×25 mm bolts and (4) M8 lock nuts and
tighten securely.
