16
NOTE: The hand held transmitter(s) and wireless wall transmitter supplied with your opener are preprogrammed
by the factory.
If you purchase additional transmitters, the garage door opener must be programmed to accept the new remote code.
Program the Receiver to Match Additional Transmitter Codes:
Using the yellow “LEARN” Button
1.Press and Hold the button on the hand-held remote or wall button that you wish to use (1).
2.Press and release the yellow “LEARN” buton on the opener (2).
3.Release the remote button when the opener light flashes. It has learnt the code. If you release the remote control push
button before the opener light flashes, the opener has not learned the code.
Now the opener will operate the door when the remote control push button is
pressed.
To Erase all Remote Control Codes
1.Press and Hold the yellow “LEARN” button on the opener until the indicator LED goes ON, and continue holding for approx.
6 seconds, until the indicator LED goes out.
1.Release the button, all codes are now erased.
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should
enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s).
Do not allow children to play near the door.
1
27
WIRELESS PROGRAMMING (OPTIONAL ACCESSORIES)
