To open the door
manually:
The door should be fully
closed if possible. Pull
down on the manual
release handle and lift
the door manually. To
reconnect the door to the
opener, press the Door
Control button.
Activate opener with any of the following devices:
•
The Remote Control: Hold the push button down
until the door starts to move.
•
The Door Control: Hold the push button down
until the door starts to move.
•
The Outside Keylock or Keyless Entry.
(See Accessories)
The lockout feature
prevents the trolley from
reconnecting automat-
ically. Pull the manual
release handle down
and back (toward the
opener). The door can
then be raised and
lowered manually as
often as necessary. To
disengage the lockout
feature, pull the manual
release handle straight
down. The trolley will
reconnect on the next
UP or DOWN operation.
Trolley
Trolley
Release Arm
NOTICE
Manual Release
Handle (Pull Down)
Trolley
Trolley
Release Arm
NOTICE
Manual Release Handle
(Pull Down & Back
Towards Opener)
Lockout position
Manual disconnect
position
Weak or broken springs could allow an open
door to fall (either rapidly or unexpectedly),
resulting in serious injury, death or property
damage. If possible, use the manual release
rope and handle
only when door is fully
closed.
Operation of Your Opener
WARNING
When the opener is activated with the safety
reversing sensor installed and correctly aligned:
1. If open, door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop (allowing space for
entry and exit of pets and for fresh air).
4. If the door has been stopped in a partially open
position, it will close.
5. If obstructed while closing, the door will reverse.
6. If obstructed while opening, the door will stop.
7. The door will reverse in the closing cycle, and the
opener light will blink for 5 seconds, when the
invisible beam is broken. If fully open, the door will
not close when the beam is broken. Sensor has no
effect in the opening cycle.
If the sensor is not installed or aligned correctly, you
can't close the door from any remote control
transmitter. However, you can close the door with the
Door Control, the Outside Keylock, or Keyless Entry,
if you activate them
until down travel is complete. If
you release them too soon, the door will
reverse.
The Opener Light will turn on under the following
conditions: When the opener is initially plugged in;
when the power is interrupted; when the opener is
activated. They will turn off automatically after
4-1/2 minutes or provide constant light when the Light
feature is activated.
Light will also turn on when someone walks through
the open garage door. Bulb size is 75 watts
maximum.
32
Press to open or close the door.
Press again to
reverse the door during the closing
cycle or to
stop the door while it's opening.
Operation of the Lighted Door Control
(See additional programming features, next page.)
