SECURITY
✚
Single-Function Remote Control
Push Button
Smart (learn)
Button
Indicator
Light
BACK
PANEL
1
3
9
7
5
1
3
9
7
5
1
2
3
SECURITY
✚
Garage Door Opener
KG
KG
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the Door Control or remote control
transmitter(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
33
Figure 1
WARNING
Receiver and Remote Control Programming
NOTICE: To comply with FCC/IC rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the
code setting or replacing the battery. THERE ARE NO OTHER USER
SERVICEABLE PARTS.
Figure 2
Your garage door opener receiver and remote
control transmitter have been set at the factory to a
matching code. The door will open when you press
the remote control push button. The code between
the remote control and the receiver changes with
each use, randomly accessing over 100 billion new
codes.
Your SECURITY
✚
opener will operate with:
• several SECURITY
✚
remote controls utilizing up
to 8 functions.
• one Keyless Entry System (with SECURITY
✚
logo)
Follow the instructions below to program your
opener to match any additional remotes you may
purchase. See Accessories on page 38.
To Add A Remote Control
1. Press and
hold a button on the remote to be
programmed. See Figure 1.
2. Then press and release the Smart (learn) button
on the back panel of the opener, Figure 2. The
indicator light on the panel will begin to blink and
the opener light will
flash once.
3. Release the remote push button.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the Smart button on the opener for
6 seconds. The indicator light will turn on. Release
the Smart button when it turns off. All codes are now
erased from the opener. Then follow the steps above
to re-program each remote control.
Code programming instructions are also located
on the opener panel.
