24
WOOD DOOR
METAL DOOR
- Finished Ceiling -
HORIZONTAL
AND VERTICAL
REINFORCEMENT
IS NEEDED FOR
LIGHTWEIGHT
GARAGE DOORS
(FIBERGLASS,
ALUMINUM,
STEEL, DOORS
WITH GLASS
PANEL, ETC).
(NOT PROVIDED)
Self-Threading
Screw 1/4"-14x5/8"
Top of Door
(Inside Garage)
Top of Door
(Inside Garage)
Top Edge
of Door
Top Edge
of Door
Optional
Placement
Optional
Placement
Carriage Bolt
5/16"x2"
(Not Provided)
For a door with no exposed framing, or for the
optional installation, use lag screws 5/16"x1-1/2"
(Not Provided) to fasten door bracket.
Lock
Washer 5/16"
Door
Bracket
Door
Bracket
Header
Wall
Header
Bracket
2x4
Support
Door
Bracket
Optional
Placement
of Door
Bracket
Vertical
Centerline
of Garage
Door
Nut
5/16"-18
HARDWARE SHOWN
ACTUAL SIZE
Self-Threading Screw
1/4"-14x5/8"
ONE-PIECE DOORS
Please read and comply with the warnings and
reinforcement instructions on the previous page. They
apply to one-piece doors also.
• Center the door bracket on the top of the door, in line
with the header bracket as shown. Mark either the left
and right, or the top and bottom holes.
•
Metal Doors:
Drill 3/16" pilot holes and fasten the
bracket with the 1/4"-14x5/8" self-threading screws
provided.
•
Wood Doors:
Drill 5/16" holes and use 5/16"x2" carriage
bolts, lock washers and nuts (not provided) or
5/16"x1-1/2" lag screws (not provided) depending on
your installation needs.
NOTE:
The door bracket may be installed on the top edge
of the door if required for your installation. (Refer to the
dotted line optional placement drawing.)
