Safety
Reversing Sensor
Support bracket &
fastening hardware
is required.
Refer page 12.
—
—
—
—
—
—
—
—
Header Wall
FINISHED CEILING
Torsion
Spring
Safety
Reversing Sensor
Gap between floor and bottom
of door must not exceed 6 mm
Access
Door
Wall-
mounted
Door
Control
Opener
Vertical
Centreline
of Door
3
SECTIONAL DOOR INSTALLATION
Planning
Identify the type and height of your garage door. Survey your garage area to see if any of the conditions below apply to
your installation. Additional materials may be required. You may find it helpful to refer back to this page and the
accompanying illustrations as you proceed with the installation of your opener.
NOTE: Door types are referenced A, B and C throughout the manual.
A
Access
Door
Safety Reversing Sensor
Gap between floor and bottom of door
must not exceed 6 mm.
Safety Reversing Sensor
ONE-PIECE TILT DOOR WITH TRACK
B
Safety Reversing Sensor
Access
Door
Safety Reversing
Sensor
Header Wall
Gap between floor
and bottom of door must not exceed 6 mm.
Wall-mounted
Door Control
Rail
C
ONE-PIECE TILT DOOR WITHOUT TRACK
