17
INSTALLATION STEP 9
Install The Protector System
TM
(optional)
Figures 1, 2 and 3 show recommended assembly of
bracket(s) and "C" wrap based on the
wall
installation of
the sensors on each side of the door shown above, or on
the
door tracks
themselves. Figure 4 shows variations
which may fit your installation requirements better.
Make
sure the wraps and brackets are aligned so the
sensors will face each other across the door.
• Connect each assembly to a slotted bracket, using the
hardware shown.
Note alignment of brackets for left
and right sides of the door.
Finger tighten the lock
nuts.
• Use bracket mounting holes as a template to locate and
drill two (4.8mm) diameter pilot holes on both sides of
the door so that the beam mounting height is no greater
than 100mm above the floor.
• Attach bracket assemblies with carriage bolts as shown.
• Adjust right and left side bracket assemblies to the same
distance out from mounting surface. Make sure all door
hardware obstructions are cleared. Tighten the nuts.
• Centre each sensor unit in a "C" wrap with lenses
pointing toward each other across the door.
• Secure sensors with the hardware provided. Finger
tighten the wing nut on the receiving eye to allow for final
adjustment. Securely tighten the sending eye wing nut.
• Run wires from both sensors to the opener and connect
the two white only wires to the white terminal and the
black/white wires to the grey terminal on your opener
(refer figure 5).
Mount Bracket
With Square Holes
Screws
“C” Wrap
Lock Nuts
Mounting Bracket
with slot
Lock Nuts
Lag Screws
Carriage Bolts
(with Square Shoulders)
Garage
Wall
“C” Wrap
Mounting Bracket
with Square Holes
Garage
wall
“C” Shaped
Wrap
Mounting Brackets
with Square Holes
Carriage Bolts
Lock Nuts
Drill
9.5mm
Holes
Garage
Track
Installing
The Protector System
to Track
ALL INSTALLATIONS
Installing
The Protector System
to the Garage Wall
TM
TM
“C” Wrap
Garage
Wall
Mounting Bracket
with Square Holes
Garage-
Floor
Mounting
Bracket
with Holes
Alternate Wall Mount
Sensor
Garage
Wall
Alternate Floor Mount
Mounting Bracket
with Slot
Mounting Bracket
with Square Holes
Holder
Sensor
Garage
Floor
Indicator Light
Indicator
Lamp
Attach with
concrete anchors
(not provided)
To protect small children, install The Protector
System™ no higher than 100mm above the floor.
Disconnect power to the garage door opener before
installing The Protector System™.
Figure 1
Figure 2
Figure 3
Figure 4
white grey
To release wires
press tab with a
screwdriver or pen
6mm
Figure 5
