5
ASSEMBLY STEP 1
Assemble the Sectional Rail (if used)
If using 1-Piece Rail Proceed to Step 5
To avoid installation difficulties, do not run the
garage door opener until instructed to do so.
•
Place rail pieces on flat surface for assembly (all four
sections are interchangeable).
•
Slide rail brace onto rail section.
•
Connect rail by sliding rail brace onto next rail section.
•
Tap rail assembly on piece of wood until rail sections
are flush (repeat with remaining rail sections until rail
assembly is complete).
ASSEMBLY STEP 2
Install the Belt
•
Remove belt from carton and lay it out on the floor, (be
careful not to allow the belt to twist).
•
Hook the trolley connector into the connector slot on
the inner trolley assembly
.
Direction Arrow
Header End
Rail Assembly
Pulley Bracket
Inner Trolley
DOOR
Rail Assembly
Wood
Rail Section
Brace
Rail Section
Connector Slot
Trolley Connector
Inner Trolley Assembly
ASSEMBLY STEP 3
Insert the Belt into the Rail
•
Slide pulley bracket and inner trolley into back
(opener
end)
of rail assembly, ensuring the pulley bracket is
inserted as shown
w
ith arrow pointing toward front
(header end)
of the rail assembly.
• Push Pulley Bracket through to the Header End of the
rail.
