NOTE: The transmitters supplied with your opener are pre-
programmed to your opener in the factory. If you purchase
additional transmitters, you will need to program them into
your opener using the steps below.
20
12
WIRELESS PROGRAMMING
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one
should enter or leave garage whilst door is in motion. Do not allow children to operate push
button(s) or transmitter(s). Do not allow children to play near the door.
Fix any wall control at a height of at least 1.5m and within sight of the door but away from any
moving parts.
close
operate
learn
Press and release
the red learn button
or
TO ADD Transmitters / Wall Control
Press and hold down the desired
button.
open
LED will flash continuously
Courtesy light will
flash once
close
operate
learn
Press and
hold the red
learn button
TO DELETE ALL TRANSMITTERS
open
LED will light up
open
LED will go out
after (approx) 9
seconds. Release
learn button
• Fix the warning against entrapment label near the
wall control (see section 16).
ADDING transmitters using the learn button
• Press and hold down the transmitter button you wish to program
to the opener.
• The orange LED will flash continuously to indicate it is receiving
signal from the transmitter.
• Press and release the learn button on the opener.
• The courtesy light will flash once.
• Ensure the door is clear of obstruction, then test the transmitter.
Deleting ALL transmitters and codes
NOTE: This deletes all transmitters and codes.
• Press and hold the LEARN button until the orange indicator light
goes out (approximately 9 sec).
To install:
• Carefully pry open the CM128 and locate the two screws for
mounting.
• Attach to the wall using the two screws and wall anchors
provided if mounting to a plaster wall. If using a recessed wall
box do not use anchors.
NOTE: Do not overtighten screws. The wall button supplied with your opener is pre-programmed to
your opener in the factory. If adding a new wall button, follow the steps below.
+
+
+
19
Disconnect power to the opener whilst installing
this accessory to prevent accidental activation.
Locate minimum 1.5m above the floor.
INSTALLING YOUR CM128 WIRELESS WALL BUTTON
