BEFORE YOU BEGIN / PREPARING YOUR GARAGE DOOR:
1. Look at the wall or ceiling above the garage door. The header bracket
must
be securely fastened to structural supports.
2. Do you have a finished ceiling in your garage? If so, a support bracket and additional fastening hardware (not supplied) may be required.
3. Depending on your door's construction, you might need a special door arm. See your dealer.
4. Do you have an access door in addition to the garage door? If not, Model CM1702 Outside Quick Release Accessory is required.
5 Disable locks.
6 Remove any ropes connected to garage door.
7. Complete the following test to make sure your garage door is balanced and is not sticking or binding:
• Lift the door about halfway as shown. Release the door. If balanced, it should stay in place, supported entirely by its springs.
• Raise and lower the door to see if there is any binding or sticking.
If your door binds, sticks, or is out of balance, call a trained door systems technician.
Sectional Door
One-Piece Door
3
Summary of Contents for Merlin MT5580
Page 1: ......
