Tools Needed:
Step Ladder
Phillips Screw Driver
Select a grounding type receptacle on either
the ceiling or wall. If one is not available, have
one installed by a qualified electrician.
IMPORTANT!
DOOR MUST CLEAR LIGHT
FIXTURE WHEN THE DOOR IS IN THE OPEN
POSITION.
Identify a mounting location for the light fixture
that’s in close proximity to the receptacle, and
within reaching distance of the power cord.
Fasten the mounting bracket to a stud, in the
desired location using (2) #10 x 1-1/2” deep
thread screws. Align the two metal tabs on the
mounting bracket. Hold the light fixture flush
against the mounting bracket using (1) #8 x
0.375” screw as shown. Place the hole plug
into the screw hole in the light fixture.
NOTE:
For temperature protection, the hole
plug must be in place prior to using the light
fixture.
TO AVOID ELECTRICAL SHOCK/FIRE,
DO NOT CHANGE THE POWER CORD
PLUG IN ANY WAY.
IMPORTANT!
THE POWER CORD HAS A
GROUNDING TYPE PLUG WITH A THIRD
(GROUNDIING) PIN. THIS PLUG WILL ONLY FIT
INTO A GROUNDING TYPE OUTLET. IF THE
PLUG DOES NOT FIT INTO YOUR OUTLET,
CONTACT A QUALIFIED ELECTRICIAN TO
INSTALL THE PROPER GROUNDING TYPE
OUTLET. DO NOT ALTER THE PLUG IN ANY
WAY.
Plug the female end of the power cord into the
inlet connect of the light fixture. Now, plug the
other end of the power cord into the nearest
grounding type receptacle. As soon as power is
applied to the light fixture it should blink one
time. Use cable clips and #6 x 7/8” wood
screws to secure the power cord.
Z-WAVE LIGHT KIT INSTALLATION
FOR TORSION I-DRIVE
Installation Instructions
P.O. Box 67 Mt. Hope, OH 44660
GARAGE DOORS & OPENERS
© 2008 Wayne-Dalton Corp. Part No. 33xxxx New 9/22/2008
www.wayne-dalton.com
This insert is to be used in conjunction with the main installaton instructions and owner’s manual.
This insert is for Z-Wave I-Drive TorqueMaster
®
Pro Operator Only!
WARNING
Mounting Bracket
(P/N 293294)
#8 x 0.375”
Phillips Pan Head
Screw
Hole Plug-Snap In
(P/N 311122-6)
(ITW Fastex 354-310102-00-2099)
(2) #10 x 1-1/2” Deep Thread
Screws (P/N 279995)
Light Fixture
Wire Clips
#6 x 7/8” Wood
Screws
Plug into nearest outlet
Screw a 15W Type-A bulb or 19W Compact
Fluorescent (maximum) light bulb into light
socket and snap diffuser into light fixture.
NOTE:
When assembling diffuser, make sure
all three snap tabs are aligned and fully
snapped into the three mating slots of the
light fixture.
Turn receptacle power back on at fuse/breaker
box. The light should blink one time when the
power is turned back on.
IMPORTANT:
FOR REPLACEMENT BULBS USE
ONLY 19W MAX COMPACT FLUORESCENT
BULBS OR USE ONLY 15W MAX TYPE-A
BULBS FOR THE LIGHT.
Top portion of Light
Fixture
Inlet Connector
Pg 1
