13
USING THE MULTI-FUNCTION DOOR
CONTROL
THE MULTI-FUNCTION DOOR CONTROL
Press the push bar to
open or close the
door. Press again to
reverse the door
during the closing
cycle or to stop the
door while it's
opening.
Light feature
The Light function is not available with the MJ3800.
Lock feature
Designed to prevent operation of the door from
hand-held transmitters whilst still allowing the door to
open and close from the Door Control, the Outdoor Key
Switch and the Keyless Entry Accessories. To activate,
press and hold the Lock button for 2 seconds.
To turn off, press and hold the Lock button again for
2 seconds. The Lock feature will also turn off whenever
the “learn” button on the opener panel is activated.
Note: This feature does not operate the Powered door
lock.
LO CK
LIG HT
Actuator
Button
LED Indicator
light
LIGHT
LOCK
AUTOMATIC CLOSE TIMER FUNCTION
Note:
Requires the Chamberlain Protector System
TM
(IR-
sensors) to be installed. If Protector System
TM
(IR-
sensors) is installed only to enable the timer to close
function (first time), install sensors, close the garage door
and wait for 5 minutes.
A Multi-function Door Control is required to enable and
disable the auto-close function.
Enable:
Push and hold lock button on the Multi-function
Door Control until the electric lock toggled twice. Release
the lock button, at the same time watch the LED light in
the center of the actuator button from the Multi-function
Door Control.
1x flash 10 seconds Auto-Close
2x flash 45 seconds Auto-Close
3x flash 2 minutes Auto-Close
4x flash 3 minutes Auto-Close
5x flash OFF Auto-Close
Factory setting is OFF. Repeat the procedure until the
Multi-function Door Control shows the required number of
flashes.
Auto close is NOT recommended for households with
young children.
Door may operate unexpectedly, therefore do not
allow anything to stay in the path of the door.
