Communications To and From Unit
Communications To and From Unit
Number of Rings Before Unit Answers:
16
Override Telephone Company Answering Service:
109
Press Then
Enable (1) or Disable (0). Then (#)
You can override an answering service by dialing the line attached to your unit, letting the
phone ring only once or twice, then hang up. After a few seconds, dial the same number
again. The unit will immediately answer the second call. If you do not call back within 60
seconds, this feature will reset and you must start over.
Factory Setting: Disabled
Example:
1
2
Page 58
Press Then
Enter Number of Rings (0 to 15). Then (#)
When someone remotely calls the unit for programming, the unit answers the call after a
configurable number of rings.
Factory Setting: 5 Rings
"0"
disables the unit and no incoming
calls will be answered. It will
NOT
be able
to be remotely programmed.
NOTE:
If you have an answering machine (or answering service) attached to the same
phone line as the unit, set the unit count for two (
2
) or more rings higher than the
answering machine/service count. See also
Override Telephone Company Answering
Service
(See Below).
Unit will Answer a Remote Call after 7 Rings
Example:
1
2
Override is enabled. The unit will answer the second call after a
few number of rings, hang up and callback is performed.
Enable or Disable Telco Mode:
20
Press Then
Enable (
1
) or Disable (
0
). Then (#)
Telco mode is using the
main
telephone line for the unit’s communications to a house or complex.
Enable
the Telco mode if the unit
will
use a regular telephone line.
Disable
the Telco mode if the unit
will not
have a regular telephone line connected to it. If the Telco
mode is disabled and the unit is connected to a regular telephone line, it will ignore
all
Telco features
(call forwarding, call waiting, etc.).
Factory Setting: Enabled
Telco mode is disabled.
Example:
1
2
Dial "0-9" First to Get an Outside Line Using an Automated Phone System:
113
Press Then
Enable (
1
) or Disable (
0
). Then (#)
When the unit is connected to a PBX telephone system (Automated), it can be programmed to dial a
specific PBX number (0-9) then pause briefly, allowing the PBX system to give the unit an outside line.
Factory Setting: Disabled
Example:
Enables Unit to dial "9 and Pause" to connect to an outside line.
1
2
3
Enter Specific PBX Digit (0-9). Then (#)
1
2
1
2
1
2
1
2
3
Summary of Contents for Elite EL Series
Page 74: ...Page 73 Notes...
Page 75: ...Page 74 Notes...
