35
To Erase All Codes From
Motor Unit Memory
To deactivate any unwanted
remote, fi rst erase all codes:
Press and hold the “learn”
button on motor unit until the
learn indicator light goes out
(approximately 6 seconds). All previous codes are now
erased. Reprogram each remote or keyless entry you
wish to use.
1. Press and release the “learn”
button on the motor unit. The learn
indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-held
remote
*
that you wish to operate
your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Add or Reprogram an Additional Hand-Held Remote Control
USING THE “LEARN” BUTTON
PROGRAMMING
NOTICE:
If this Security
✚
®
garage door opener is operated with a non-rolling code transmitter, the technical measure
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security
✚
®
remote controls.
*3-Button Remotes
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
Security
✚
®
3-Button
remote or compact
remote can be
programmed to operate
other Security
✚
®
garage door openers.
