I-PR3I-01.doc
Issue 03
18/07/2019
2
IOM
–
PROTECTA LED (IND)
0.0
Specification
Type Of Protection
N/A
Standards
EN 60598-1, EN 60598-2-22
Area Classification
Industrial, (Non- Hazardous)
Ambient
-25°C to +45°C
Ingress Protection
IP66/67 to EN 60529
CE Mark
The CE marking of this product applies to "The Electrical Equipment (Safety) Regulations
2006", "The Electromagnetic Compatibility Regulations 2004", the “Waste Electrical and
Electronic Equipment Regulations 2006”. [This legislation is the equivalent in UK law of EU
directives 2014/35/EU, 2014/30/EU, 2012/19/EU respectively].
M Poutney Technical Manager
Luminaire is supplied with Battery plug/Socket disconnected, just prior to switching
power on, connect battery plug and socket.
1.0 Introduction - Protecta Safe Area LED Luminaire
The Protecta Safe Area LED Luminaires are surface mounted or suspended, utilising the two tapped holes on
base of body, with the facility of an integral battery back-up for emergency use. Normal operation is mains supply
LEDS full on, switching to reduced LED power on battery back-up, local switching of the mains LEDS, the
emergency output only being energised on mains failure. Emergency duration: to BS EN 60598 2.22, as per
order. They are mainly used in harsh environments and are constructed using a corrosion resistant glass
reinforced polyester body attached to an injection moulded polycarbonate diffuser by hinges and a special clamp.
The control gear and LED strips are mounted on a removable tray which for maintenance has hanging straps.
2.0 Storage
Luminaires and control gear boxes are to be stored in cool dry conditions preventing ingress of moisture and
condensation. Any specific instructions concerning emergency Luminaires must be complied with.
Battery packs in storage should be cycled charged/discharged/charged every 9 months, as per instructions
below.
Always disconnect battery plug and socket for storage
.
Any specific instructions concerning emergency luminaires must be complied with.
(Warning: Battery packs not cycled and stored for a year may not be recoverable)
3.0 Installation and Safety
3.1 General
There are no health hazards associated with this product whilst in normal use. However, care should be
exercised during the following operations.
In the UK the requirements of the
'Health and Safety at Work Act'
must be met.
Handling and electrical work associated with this product to be in accordance with the
'Manual Handling
Operations Regulations' and 'Electricity at Work Regulations, 1989'
. Your attention is drawn to the paragraphs (i)
'Electrical Supplies', (ii) 'Electrical Fault Finding and Replacement' and (iii) 'Inspection and Maintenance'. The
luminaires are Class 1 and should be effectively earthed.
The information in this leaflet is correct at the time of publication. The company reserves the right to make
specification changes as required.
3.2 Tools
12mm, 5mm and 3mm flat blade screwdriver. Pozi number 2 screwdriver
Suitable spanners for installing cable glands. Pliers, knife, wire strippers/cutters.
3.3 Electrical Supplies and Control Gear
Luminaires fitted with electronic control gear are suitable for a rated supply from 120- 277Vac 50-60Hz,
127-300V dc for standard fitting and 220-240V 50/60Hz for emergency. The safety limits are +10% of this. The
supply would normally be expected to lie /-6% of rated. The LED supply is regulated, therefore the light
output over the range is substantially unchanged.
Electronic gear has integrated power factor correction to >0.90.
