HELPLINE NO 08454 505299
10
ORIGINAL INSTRUCTIONS
1. Selecting the right grade of
sandpaper
WARNING.
Always ensure that the tool is
switched off and the plug is removed from
the power point before making any
adjustments or undertaking maintenance
procedures.
2. Fitting the sand paper
To fit the sand paper :
Disconnect the plug from the electricity supply.
Fix one side of the sandpaper, flush with one
side of the backing pad, then attach the
sandpaper to the backing pad and press it
firmly into place.
3. Connect the dust port
Important! In the interests of your
health, always use the dust
extraction device when sanding.
Connect the extract adaptor to the dust
extractor connection.
OPERATION
1. Starting Operation
Observe correct mains voltage! The voltage
of the power source must match the voltage
specified on the technical plate of the machine.
Important!
Keep the cooling vents on the motor
housing clean and unobstructed at
all times. To be able to make the
best use of the sander, always use
original spare parts and accessories,
available from all specialist retailers.
Align the holes in the sandpaper
with the dust extraction holes in the
base of your sander.
WARNING.
Do not use the same sanding
sheet for wood and metal. Metal particles
become embed in the sandpaper and will
scour a wooden surface.
• Different grades of sandpaper can be
purchased from your local hardware store.
Available grades are: Coarse, Medium
and Fine.
• Use a coarse grit to sand down rough
finishes, medium grit to smooth the work
and fine grit to finish off.
• It is best to make a trial run on a scrap
piece of material to determine the optimum
grades of sandpaper for a particular job.
If there are still marks on your work after
sanding, try either going back to a coarser
grade and sanding the marks out before
recommencing with the original choice of
grit ,or try using a new piece of sandpaper
to eliminate the unwanted marks before
going on to a finer grit and finishing the
job.
The machine is intended for dry sanding of
wood, plastic, metal, Filler as well as coated
surfaces.
NOTE
: Before using the tool, read the
instruction book carefully.
INTENDED USE
ASSEMBLY
OPERATING
INSTRUCTIONS
