HELPLINE NO 08454 505299
11
ORIGINAL INSTRUCTIONS
2. Switching On and Off
Switch on:
Press ON/OFF switch. at the position “I”
Switch off:
Press ON/OFF switch at the position ”O”
3. Sanding Surfaces
4. Rough Sanding
Attach a sanding sheet with coarse grain.
Apply only light pressure to the machine so
that it runs at a higher stroke rate and high
material removal is achieved.
5. Fine Sanding
Attach a sanding sheet with fine grain.
By lightly varying the application pressure or
changing the orbital stroke rate,
the sanding plate stroke rate can be reduced
whereby the orbital action is maintained.
With moderate pressure, move the machine
in a circular pattern or alternately in lengthwise
and crosswise directions over the work piece.
Do not tilt the machine to avoid sanding
through the work piece (e.g. when sanding
veneer)
Switch the machine on, place it with the
complete sanding surface on the surface to
be worked and move the machine with
moderate pressure over the work piece.
The removal capacity and the sanding pattern
are mainly determined by the selection of the
sanding sheet, and the applied pressure.
Flawless sanding sheets will optimize
sanding capability and extend the service life
of the machine.
Apply uniform sanding pressure; this increases
the working life of the sanding sheets.
Intensifying the sanding pressure does not
lead to an increase of the sanding capacity,
but to increased wear of the machine and
the sanding sheet.
A sanding sheet that has been used for metal
should not be used for other materials.
Use only original sanding accessories.
Working Advice
Wait until the machine has come to a stand
still before placing it down on any surface.
MAINTENANCE
• Before undertaking any work on the machine
itself, pull the mains plugunplug the power
supply.
• For safe and proper workingoperation, always
keep the machine and ventilation slots clean.
• Regularly check to see if any dust or foreign
matter has entered the grills near the motor
and around the on/off switch. Use a soft brush
to remove any accumulated dust.
• Wear safety glasses to protect your eyes
whilst cleaning.
• If the body of the tool needs cleaning, wipe it
with a soft damp cloth. A mild detergent can
be used but nothing like alcohol, petrol or
other such cleaning agents.
• Never use caustic agents to clean plastic part.
• Lubricate all moving parts at regular intervals.
