HELPLINE NO 08448012949
8
OrIgINaL INstructIONs
charger, the screwdriver should be ready to
use.
Fig.A1
Fig.A2
Important:
When charging, the charger and screwdriver
may become warm to the touch, this is
normal and does not indicate a problem.
OPEratINg INstructIONs
Inspect the screwdriver before using to
ensure all parts are running smoothly and
there no abnormal sounds or sparks. Before
driving fasteners, check behind walls for
wire, other electrical hazards or plumbing.
Clear the work area of all parts and debris
that may cause injury by flying objects.
Securely fix the object to be fastened in a
vice or otherwise clamp to avoid injury. Do
not attempt to hold work-piece by hand.
1. FIttINg aND rEMOvINg BIts
To use any one of the short bits supplied,
insert the bit into the chuck as far as
possible. To remove the bit, simply pull it out
of the chuck. (See Fig.B)
rEcHargINg BattErIEs
NOtE:
Before using the tool, read the
instruction book carefully.
INtENDED usE
This tool is intended for the fastening
and loosening of bolts, nuts and various
threaded fasteners. This tool is not intended
for use as a drill.
a) cHargINg tHE BattErY
The battery charger supplied is matched to
the Li-ion battery installed in the machine.
Do not use another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit: the tool holder no longer
rotates.
In a warm environment or after heavy use,
the battery pack may become too hot to
permit charging. Allow time for the battery to
cool down before recharging.
When the battery is charged for the first
time and after prolonged storage, the
battery will only accept approximately 60%
charge. However, after several charge and
discharge cycles the battery will accept a
100% charge.
B) IMPOrtaNt NOtEs FOr cHargINg
tHE BattErY
The battery in your new Screwdriver is not
charged when it leaves the plant. Therefore
it must be charged for 3~5 hours before
using the first time!
c) cHargINg for csD36L.1 (see Fig.
a1, a2)
Plug charger plug into a suitable power
outlet and afterwards place the screwdriver
onto the battery charger, the charging
indicator (Orange) (4) will illuminate at this
time.
Let the battery charge for 3~5hours. This
will give the battery a full charge, the
charger indicator (orange) will go out when
charging is complete. Then unplug the
charging plug from the wall socket and
remove the screwdriver from the battery
