CHAINTECH CT-6BJM, User Manual

Page: 48 / 58

User's Manual
44
B. USB Keyboard Support
If your current operating system doesn't support USB drivers (i.e., DOS) this
function must be enabled for USB keyboard operation in these operating systems.
!
When using a USB keyboard this function is automatically Enabled during
bootup regardless of its setting in BIOS.
C. Init Display First
This function allows user to choose between AGP slot or VGA slot to initialize
Display first .
D. Power On Function
Set to BUTTON ONLY to control your computer's power on function of your
system case. Select a function to turn on your computer. If you set this function
to Hot Key or Password you must designate the keystrokes or password that will
turn on the computer. Note that the power button is always able to turn on the
computer regardless of how this function is set.
If you have forgotten your passord, you must remove the power cable from
the ATX power supply connector and clear the CMOS data as discussed
in Section 2-4 to clear the password.
E. Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install an add-in FDC or the system
has no floppy drive, select Disabled in this field.
F. COM2 Mode Select
This function allows you to select an operating mode for the second serial port.
( Normal RS-232C serial port /IrDA SIR 1.0 specification/ ASKIR 0.57-MB/sec
infrared port)
G. Onboard Parallel Port
Select a logical LPT port address and corresponding interrupt for the physical
parallel port.
H. Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select
SPP unless you are certain your hardware and software support one of the other
available modes.
I. Power Failure Recovery
Computers using an ATX power supply do not turn back on after the power source
to the computer unexpectedly fails (i.e. electricity outage). Enabling this setting
will allow the system to always turn back on after a power failure. This is especially
important for computers that must be on 24 hours per day
!