CHAINTECH 6WIV0, Manual, Page: 19 / 29

Chapter 2
16
Normal(default)
1
L
1
R
GND
1
Clear CMOS data
+
+
+
+
+
+
+
+
+
1
1
Speaker out
Line out
This jumper allows you to select between audio line-out
or speaker out function. Set both JP9 and JP10 pins to
1-2 for line-out function or set both JP9 and JP10 pins
to 2-3 for speaker out function..
Audio Line out and Speaker out Jumper(JP9/JP10)
CMOS Setting (JP5)
To clear the contents of the CMOS, please follow the
steps below.
1. Disconnect the system power supply from the power
source.
2. Set the jumper cap at location 2~3 for 5 seconds, then
set it back to the default position.
3. Connect the system's power and then start the system.
4. Enter BIOS's CMOS Setup Utility and choose Load
Setup Defaults. Type Y and press enter.
5. Set the system configuration in the Standard CMOS
Setup menu.
Chassis Intrusion Detection (JP8)
This board supports the chassis instruction detection
feature of the management extension hardware by means
of a mechanical or photo sensor switch attached to the
motherboard through this 1x3-pin chassis security header.
The mechanical switch is set to open for normal computer
operation.
CD-ROM Audio-in Connector(CN1)
Use the audio cable enclosed with your CD-ROM disk
drive to connect the CD-ROM to your mainboard. This
will enable your CD-ROM's audio function.
JP9 JP10 JP9 JP10