CHAINTECH 6WIV0, Manual, Page: 16 / 29

Hardware Setup
13
Blinking LED in Suspend Mode
While in Suspend mode, the LED light on the front panel of your computer will flash.
Suspend mode is entered by pressing the Override Power Button, pushing the Green
button on your ATX case, or enabling the Power Management and Suspend Mode
options in BIOS's Power Management menu.
C. System Reset Switch Connector
This connector should be connected to the reset switch
on the front panel of the system case. The reset switch
allows you to restart the system without turning the
power off.
D. Speaker Connector
E. IDE Activity LED Connector
The IDE activity LED lights up whenever the system
reads/writes to the IDE devices.
Infrared Connector
If you enable the IR Address Select in BIOS's Integrated
Peripherals menu the IR port will support IR functions.
+
+
+
Pin Definition
1 System
2 GND
PIN Definition
1 Speaker Signal
2 NC
3 NC
4 +5V DC
Power Indicator LED
Speaker Header
Green LED
Reset Switch
Over-ride Power Button
KeyLock
IDE Activity LED
+
+
+
1
+
+
+
GND
Ir-Tx
1
Ir-Rx
5VSB
5VSB