Page: 45/81 User Manual PSU-CTRL-2D, Rev.1-00: Software Interface
Return
value
Error message
Description
-16
Error setting the
baud rate
The data rate could not be set.
Check if the host is able to commu-
nicate at the desired speed.
-100 Device
not
connected
The port status lines indicate that
the device is not connected.
-101
Device not ready
The port status lines indicate that
the device is not ready. Communi-
cation with the device is only possi-
ble if it is not executing any proc-
ess.
-102 Device
state
could
not be set to not
ready
The device did not react properly.
Try to reset the communication or
restart the device by powering it off
and on.
-400
Error opening the
file for debugging
output
The file for the debugging output
cannot be opened for writing.
Check if you have permission to
perform this action or if the file al-
ready exists and is in use by an-
other application.
-401
Error closing the file
for debugging output
The file for the debugging output
cannot be closed. Check if access
to the file is still possible.
CGC Instruments
Tel.: +49 (371) 355 098–55
Hübschmannstr. 18 | D–09112 Chemnitz
Fax: +49 (371) 355 098–60
internet: www.cgc-instruments.com
e–mail: [email protected]
