18
Figure V:
Step 35:
Loosen and remove the nut and washer
used to attach the electrode (36) as shown, being
careful not to let the screw fall out the other side. Use
the ground wire (40) found in the kit, and slip the
eyelet of the ground wire over the open end of the
screw. Re-attach the nut and washer, and tighten
securely.
Locate the electrode wire (5a) in your kit and attach it
to the end of the electrode.
40
36
5a
Figure W:
Step 36:
Attach the ground wire and the electrode
wire to the terminals on the back of the igniter as
shown.
Note: It does not matter to which terminal each
wire is attached, as long as each wire makes a
good connection.
Figure V
Figure W
Figure W
Figure U:
Step 33:
Step 34:
Mount the right side table bracket (33)
to the side burner table (31) as shown above,
using two of the screws previously removed in
step 30. Securely tighten the screws.
Mount the right side condiment tray
(32) to the side burner table (31) as shown
above. The side burner valve (b) must be
inserted into the end of the burner tube (c).
Secure the tray
the
remaining
using
two
screws
previously removed in step 30. Securely tighten
the screws.
Note: The shutter cap on the end of the burner
tube (c) may require tightening of the screw. The
burner shutter opening should be adjusted to
meet ideal flame character as described on
page 31.
Figure U
32
31
33
b
c
