background image

4

Never expose eyes or skin to UVC light from any source. Looking directly at the UVC

light may cause permanent eye damage or blindness. Never operate the CX-Pro Air Purifying System out
of the plenum. Avoid touching the glass portion of the lamp with your hands.

WARNING

INSTALLATION

STEP 1.  CHOOSE A LOCATION FOR THE CX-PRO 

To prevent water damage or electric shock, do NOT mount unit under a humidifier.

A. CX-Pro may be installed in supply duct, return plenum or above AC coil.
B. CX-Pro may be installed in upflow, downflow, or horizontal flow ducts and plenums. 
C. CX-Pro may be installed directly onto a sheet metal air duct, or onto a fiberglass ductboard

when installed using the included ductboard adapter plate.

D. If locating a CX-Pro above an AC coil: position so that the maximum surface area of the AC

coil is illuminated, installing as close to the AC coil as possible without damage to the AC coil. 

E. DO NOT locate within 30 inches (direct exposure) of plastic materials or air filters.

Use care to avoid damage to the AC coil, wiring or other components while

installing the CX-Pro.

STEP 2.  UVC LAMP & BALLAST

Unplug the unit before installing the lamp.

A. The ballast is factory set to 120 VAC. The voltage can be changed in the field to 230 VAC by

sliding the voltage selector switch to the 230 volt position (Figure 1). The plug must be replaced
and wiring must be done to applicable electrical codes.

B. Remove front electrical cover by removing (2) sheet metal screws on sides.
C. Do not touch the glass section of the lamp with bare hands. Wear oil-free cotton gloves when

handling germicidal lamp. 

D. Remove lamp from packaging and slide non-pinned end through grommet.
E. Loosen lamp clip and insert lamp so that the end of the lamp is inside the unit. 
F.

Tighten lamp clip using the brass knurl. Make sure the lamp clip tightens around the plastic
part of the lamp and not the glass (Figure 2).    

G. Connect ballast to the four pins on the lamp using the connector (Figure 3).
H. Wipe down the lamp with the supplied alcohol wipe.

NOTICE

CAUTION

Figure 3

Figure 2

Figure 1

WARNING

Summary of Contents for CX-PRO









Reviews: