-33-
PRO
PILOT
725 INSTALLATION & SERVICING MANUAL
Configuring
Your
Propilot
725
R E S T O R E
Press
either
the or key at this display to select the
values that were stored when the autopilot was last switched
off. This is useful if you are experimenting with different
settings.
Press the SEA STATE key to return you to the Configuration
window or OFF to exit this routine and store the settings.
Adjusting Individual Configuration Settings
PILOT B
Press the ‘MODE’ key and select PILOT A, PILOT B or PILOT C
settings.
C O N F I G
Press and hold the SEA STATE key until the LCD displays the
Configuration message (approximately 3 seconds).
TRIM--06
Press the SEA STATE key repeatedly to select the required
setting (The TRIM setting in this example).
T R I M ¦ 0 9
Press the key and the value will increase, an arrow
confirms that it is increasing.
T R I M
§
0 7
Press the key again and the value will decrease, an arrow
confirms that it is decreasing.
The SEA STATE key will step through the other
Configuration adjustments or the AUTO or ON/ST'BY keys
will take you back to their displays.
For all settings, the value displayed is the one that the
Autopilot will use but...REMEMBER changed settings will
only be stored if the Autopilot is turned off by the OFF key
being pressed.
