CETAC Aridus II, Operator'S Manual

Page: 53 / 62

Aridus II™ Operator’s Manual
Chapter 8: Safety and Regulatory Information
53
Safety Notices
INJURY HAZARD
If the equipment is used in a manner not specified by CETAC Technologies,
the protection provided the equipment may be impaired.
Repair or service that this not covered in this manual should only be
performed by qualified personnel.
Power Cord Set Requirements and Maintenance
The power cord set supplied with your instrument meets the requirements of
the country where you will use the instrument. Power is supplied to the
autosampler through the included 24V power supply.
The operator should check the power supply cord condition. The equipment
should not be operated if the mains inlet is cracked or broken. Any obvious
damage to the case (from a drop or fall) should be checked by service
personnel for loose or damaged parts. See individual parts lists for approved
replacement parts.
Mains Disconnect
The power switch on the rear panel is not the mains disconnect. Power mains
disconnect is accomplished by unplugging the power cord at the instrument or
at the wall outlet. Ensure the power cord is easily accessible and removable, in
the event of an emergency which requires immediate disconnection.
SHOCK HAZARD
Ensure that power cord is disconnected before removal of any covers.
WARNING
WARNING